Parker Solenoid Valve Wiring Diagram
Parker Solenoid Valve Wiring Diagram. This solenoid work with 24vdc and have 3 pin/ wire. This wiring diagram represents only a proposal.
• 345 bar (5000 psi) pressure rating. How to switch the solenoid valve position (from a to b and from b to a) with 2 wire 24v adapter (24v and gnd)? I will never tried to wiring directly without enough information.
= Not Available Rewiring Vrd350/355 To Series Pxd !
Solenoid valves consist of two main elements: The user is responsible for the final verification of the connection order. They are used for the remote on/off or directional control of liquids, gases and steam.
Capable Of Pressures Up To 350 Bar (5000 Psi) And Flows Up To 260 Lpm (70 Gpm).
Wiring and fusing (when used) must comply with prevailing local and national wiring codes and ordinances. The solenoid is the electromagnetic Use wire number 2 for single solenoid valves and wire numbers 1 and 4 for
• 345 Bar (5000 Psi) Pressure Rating.
Parker 2 way normally open 1 general purpose solenoid valves na. • choice of five operator styles. Use wires marked “3” and “4” for solenoid “14”.
Use Wires Marked “1” And “2” For Solenoid “12”.
In this section we highlight the features and discuss some of the available options. See page 7 for spool function chart. The spool is directly shifted by a variety of operators including:
Air Bleed (See Step 5 Bullet 3 On Page 4) Air Bleed (See Step 5 Bullet 3 On Page 4)
Wiring of the solenoid valve is simple. This illustrates which wires to connect for either 120, 208 or 240 volt operation. Directional control valve operating instructions series d1vw ee.
Post a Comment for "Parker Solenoid Valve Wiring Diagram"